Remove and reinstall four wheels and rear brake drums if applicable to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front ( 55 %) Rear ( 55 %)
DAVE S. gave our service a 5 star review on 4/8/2023
SCANNED FOR CODES HAS CODE FOR LOW VOLTAGE IGNITION 1 CIRCUIT, GENERATOR L TERMINAL CIRCUIT AND ENGINE CONTROLS IGNITION RELAY FEEDBACK CIRCUIT LOW VOLTAGE, FOUND A TERMINAL UNDER THE FUSE BLOCK WAS CAUSING THE PROBLEM, FOUND A TECH BULLETIN FOR THIS PROBLEM, INSTALLED A NEW TERMINAL IN THE CONNECTOR TO FIX THE PROBLEM.
ED S. gave our service a 5 star review on 3/29/2023
Replace rear brake pad linings and rear brake disc rotors. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Bleed air from system. Road test vehicle.
CABIN AIR FILTER – Remove & Replace
AUSTIN L. gave our service a 5 star review on 3/27/2023
SCANNED SYSTEM AND FOUND MULTIPLE CODES FOR EVAP SYSTEM OPEN CIRCUIT OR CIRCUIT HIGH VOLTAGE. COMMANDED DIFFERENT COMPONENTS OF THE EVAP SYSTEM TO SEE IF THEY WERE RESPONDING, NO RESPONSE OUT OF VENT OR CANISTER. VISUALLY INSPECTED WIRES AND CONNECTIONS AT COMPONENTS AND FOUND CHEWED WIRES AT BOTH COMPONENTS. REPAIRED 7 WIRES AND COMMANDED COMPONENTS ON, ALL SYSTEM IS WORKING AS IT SHOULD.
ROBERT D. gave our service a 5 star review on 3/17/2023